Siemens SINUMERIK 802D

Table of contents
Cylindrical grinding
8 Programming and Operating Manual, 07/2009, 6FC5398-4CP10-2BA0
6.3 Selection and start of a part program.......................................................................................... 84
6.4 Block search................................................................................................................................
86
6.5 Simultaneous recording ..............................................................................................................
89
6.6 Stop / cancel a part program.......................................................................................................
92
6.7 Reapproach after cancellation ....................................................................................................
93
6.8 Repositioning after interruption ...................................................................................................
94
6.9 Execute from external .................................................................................................................
95
7 Part programming....................................................................................................................................
99
7.1 Part programming overview ........................................................................................................
99
7.2 Enter new program....................................................................................................................
103
7.3 Editing the part program............................................................................................................
104
8 System...................................................................................................................................................
107
8.1 "System" operating area ...........................................................................................................
107
8.2 SYSTEM - "Start-up" softkeys...................................................................................................
112
8.3 SYSTEM - "Machine data" softkeys..........................................................................................
113
8.4 SYSTEM - "Service display" .....................................................................................................
120
8.4.1 Action log...................................................................................................................................
122
8.4.2 Servo trace................................................................................................................................
123
8.4.3 Version/HMI details...................................................................................................................
127
8.4.4 Service MSG .............................................................................................................................
131
8.5 SYSTEM - "PLC" softkeys ........................................................................................................
137
8.6 SYSTEM - "Start-up files" softkeys ...........................................................................................
145
8.7 Alarm display.............................................................................................................................
150
9 Cycles....................................................................................................................................................
153
9.1 Overview of cycles ....................................................................................................................
153
9.2 Programming cycles..................................................................................................................
155
9.2.1 Call and return conditions .........................................................................................................
155
9.2.2 Error messages and error handling ..........................................................................................
156
9.2.2.1 General information...................................................................................................................
156
9.2.2.2 Error handling within cycles ......................................................................................................
156
9.2.3 Cycle call and parameter list.....................................................................................................
157
9.3 Special characteristics of grinding cycles .................................................................................
158
9.4 Zyklenunterstützung im Programmeditor ..................................................................................
161
9.5 Taper grinding - CYCLE405......................................................................................................
164
9.6 Z positioning with grinding wheel - CYCLE406.........................................................................
167
9.7 Obstacle diameter - CYCLE407................................................................................................
169
9.8 Plunge-cutting - CYCLE410......................................................................................................
170
9.9 Multiple plunge-cutting – CYCLE411 ........................................................................................
175
9.10 Shoulder plunge-cutting – CYCLE412 ......................................................................................
181