Automatic mode
6.1 Automatic mode
Cylindrical grinding
82 Programming and Operating Manual, 07/2009, 6FC5398-4CP10-2BA0
Displays the "Regrinding" window.
Enter the compensation values for regrinding. When you select "OK", the parameters will be
inserted in the program after the selected block.
It is possible to simultaneously record when the part program is executed (see Chapter
"
Simultaneously recording (Page 89)").
Use this softkey to correct a fault program passage. Any changes will be stored immediately.
5H
JULQG
6LPXOWDQHRXV
UHFRUGLQJ
&RUUHFW
SURJUDP
To Next Page
Loading...
