Automatic mode
6.4 Block search
Cylindrical grinding
88 Programming and Operating Manual, 07/2009, 6FC5398-4CP10-2BA0
Regrinding
"Regrinding" enables you to remachine the "seat" of a workpiece that has already been
machined, either with or without an offset, but always with the same technological values.
Displays the "Regrinding" window.
Figure 6-9 Regrinding
Enter the compensation values for regrinding.
Choose between the following options in the toggle field:
● Do not correct any axis
● Correct tool
● Machining offsets
When you select "OK", the parameters will be inserted in the program after the selected
block.
The block search starts.
5H
JULQG
To Next Page
Loading...
Need help?
General
