Operation Type
1)
Meaning W
2)
TP
3)
SA
4)
Description see
5)
1) 2) 3) 4) 5)
for explanations, see legend (Page 1197).
OSP2 K Oscillation right reversal point m + PM-NC
OSS G Tool orientation smoothing at end of block m + PM-NC
OSSE G Tool orientation smoothing at start and end of
block
m + PM-NC
OST G Smoothing of tool orientation by specifying an‐
gular tolerance in degrees with SD (maximum
deviation from programmed orientation char‐
acteristic)
m + PM-NC
OST1 K Oscillating: Stopping point in left reversal point m + PM-NC
OST2 K Oscillating: Stopping point in right reversal
point
m + PM-NC
OTOL A Orientation tolerance for compressor func‐
tions, orientation smoothing and smoothing
types
m + - PM-NC
OTOLG0 A Orientation tolerance for rapid traverse move‐
ments
m + - PM-NC
OVR K Speed offset m + PM-NC
OVRA K Axial speed offset m + + PM-NC
OVRRAP K Rapid traverse override m + PM-NC
P A Number of subprogram repetitions + PM-NC
PAROT G Align workpiece coordinate system on work‐
piece
m + PM-NC
PAROTOF
6)
G Deactivate frame rotation in relation to work‐
piece
m + PM-NC
PCALL K Call subprograms with absolute path and pa‐
rameter transfer
+ PM-NC
PDELAYOF G Punching with delay OFF m + PM-NC
PDELAYON
6)
G Punching with delay ON m + PM-NC
PHI K Angle of rotation of the orientation around the
direction axis of the taper
+ PM-NC
PHU K Physical unit of a variable + PM-NC
PL A 1. B spline: Node clearance
2. Polynomial interpolation Length of the pa‐
rameter interval for polynomial interpolation
s + PM-NC
PM K Per minute + PM-NC
PO K Polynomial coefficient for polynomial interpo‐
lation
s + PM-NC
POCKET3 C (T) Milling the rectangular pocket + PM-NC
POCKET4 C (T) Milling the circular pocket + PM-NC
POLF K LIFTFAST retraction position m + PM-NC
POLFA P Start retraction position of single axes with
$AA_ESR_TRIGGER
m + + PM-NC
POLFMASK P Enable axes for retraction without a connec‐
tion between the axes
m + - PM-NC
Tables
4.1 Operations
NC programming
Programming Manual, 12/2019, 6FC5398-2EP40-0BA0 1223
To Next Page
Loading...
