Siemens SINUMERIK 840D

Detailed Description
2.3 Configurable gear adaptation
Basic logic functions: Spindles (S1)
Function Manual, 11/2006, 6FC5397-0BP10-2BA0
45
6SLQGOHVSHHG
0D[LPXPVSLQGOHVSHHG
0D[LPXPVSHHGRIJHDUVWHS
0D[LPXPVSHHGIRUJHDUFKDQJH
0D[LPXPVSHHGRIJHDUVWHS
0D[LPXPVSHHGIRUJHDUFKDQJH
0LQLPXPVSHHGIRUJHDUFKDQJH
0LQLPXPVSHHGIRUJHDUVWHS
0LQLPXPVSHHGIRUJHDUFKDQJH
UHYPLQ
*HDU VWHS

0LQLPXPVSHHGIRUJHDUVWHS
*HDU VWHS
Figure 2-7 Example for two "gear steps with overlapping speed ranges" for automatic gear step
change (M40)
Note
An active reduction gear is not considered in the selection for the automatic gear stage
change.