EasyManuals Logo

Siemens SINUMERIK 840D Function Manual

Siemens SINUMERIK 840D
2184 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #1759 background imageLoading...
Page #1759 background image
Detailed description
2.3 Feedrate control
Basic logic functions: Feeds (V1)
Function Manual, 11/2006, 6FC5397-0BP10-2BA0
43
2.3.6 Multiple feedrate values in one block
Application
The functionality described in the following is used primarily for grinding, but is not restricted
to it.
References:
/FB2/ Function Manual, Extended Functions; Grinding (W4)
/FB2/ Function Manual, Extended Functions; Oscillation (P5)
Functionality
The function "Multiple feedrates in one block" can be used to activate 6 different feedrate
values of an NC block, a dwell time or a retraction motion synchronously, depending on the
external digital and/or analog inputs.
Retraction
Retraction by the programmed amount is initiated in the IPO cycle.
Signals
The HW input signals are combined in one input byte for the function "Multiple feedrate in
one block". A permanent functional assignment applies within the byte:
Table 2-1 Input byte for "Multiple feedrates in one block"
Bit 7 Bit 6 Bit 5 Bit 4 Bit 3 Bit 2 Bit 1 Bit 0
Input no.
I7 I6 I5 I4 I3 I2 I1 I0
Feedrate address
F7 F6 F5 F4 F3 F2 ST SR
I7 to I2
Activation of feedrates F7 to F2
I1
Activation of dwell time ST (in seconds)
I0
Activation of retraction motion SR

Table of Contents

Other manuals for Siemens SINUMERIK 840D

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Siemens SINUMERIK 840D and is the answer not in the manual?

Siemens SINUMERIK 840D Specifications

General IconGeneral
SeriesSINUMERIK 840D
AxesUp to 31
ChannelsUp to 10
Operating SystemWindows-based
Power Supply24 V DC
Control Unit TypeCNC
InterfaceEthernet, PROFIBUS
DisplayTFT color display
InterpolationSpline
PLCIntegrated PLC
Data StorageCompactFlash, USB

Related product manuals