Siemens SINUMERIK 840D - Page 126

2
Operation 10.04
2.10 Automatic mode
2
 Siemens AG, 2004. All rights reserved
2-126 SINUMERIK 840D/840Di/810D Operation/Programming ShopMill (BAS) – 10.04 Edition
Cycle Start
 Press the "Cycle Start" key again each time.
Execution of the program is continued.
Program.
stop
 Press the "Program. stop" softkey again if you want the program
to be executed without a programmed stop. (The softkey is
deactivated again.)
Skipping G code blocks
 Load a program in "Machine Auto" operating mode (see Sec.
"Selecting a program for execution").
 Press the "Prog. Cntrl." softkey.
Skip
 Press the "Skip" softkey.
Cycle Start
 Press the "Cycle Start" key.
Execution of the program starts. G code blocks with the "/" character
(slash) in front of the block number are not executed.
Skip
 Press the "Skip" softkey again if you want the marked G code
blocks to be executed again during the next run. (The softkey is
deactivated again.)
Allowing DRF offset
 Load a program in "Machine Auto" mode (see Sec. "Starting/
stopping program execution").
 Press the "Prog. Cntrl." softkey.
DRF
offset
 Press the "DRF offset" softkey.
Cycle Start
 Press the "Cycle Start" key.
Execution of the program starts. Offsets with the handwheel affect the
machining process directly.
DRF
offset
 Press the "DRF offset" softkey again if you no longer want to
allow handwheel offsets during machining. (The softkey is
deactivated again.)