Siemens SINUMERIK 840D - Selecting Multiple Programs

6
File Management 10.04
6.3 Pro
g
ram mana
g
ement with PCU 50
6
 Siemens AG, 2004. All rights reserved
6-376 SINUMERIK 840D/840Di/810D Operation/Programming ShopMill (BAS) – 10.04 Edition
6.3.7 Selecting multiple programs
You can select several programs individually or in a block for
subsequent copying, deleting, etc.
Selecting several
programs as a block
 Open the Program Manager.
 Place the cursor on the first program that you want to select.
Mark
 Press the "Mark" softkey.
-or-
 Expand the program selection area by pressing the cursor up or
down key.
The entire block of programs is marked.
Selecting several
programs individually
 Open the Program Manager.
 Place the cursor on the first program that you want to select.
 Press the "Select" key.
-or-
 Move the cursor to the next program that you want to select.
 Press the "Select" key again.
The individually selected programs are marked.