Siemens SINUMERIK 840D - Page 362

6
File Management 10.04
6.2 Pro
g
ram mana
g
ement with PCU 20
6
 Siemens AG, 2004. All rights reserved
6-362 SINUMERIK 840D/840Di/810D Operation/Programming ShopMill (BAS) – 10.04 Edition
Stop
been exported and the number of bytes transferred.
 Press the "Stop" softkey if you want to interrupt data transfer.
 Then press the "Start" softkey again to restart data transfer.
Importing a program
 Open the Program Manager.
Continue
>
Read in
 Select the "Continue" and "Read in" softkeys.
RS-232
settings
 Press the "RS-232 settings" softkey to set up the interface.
 Enter the desired settings.
 Press the "Back" softkey.
The settings for the interface are saved.
 On the partner system, select the programs that you want to read
in.
 Start the transfer on the partner system.
Start
 Press "Start" softkey.
The "Read in" window displays the name of the program that has just
been read in and the number of bytes transferred. The program is
stored in the directory specified in the program header.
Stop
 Press the "Stop" softkey if you want to interrupt data transfer.
 Then press the "Start" softkey again to restart data transfer.