EasyManua.ls Logo

Siemens SINUMERIK 840D - Page 381

Siemens SINUMERIK 840D
472 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
6
10.04 File Management
6.3 Pro
g
ram mana
g
ement with PCU 50
6
Siemens AG, 2004. All rights reserved
SINUMERIK 840D/840Di/810D Operation/Programming ShopMill (BAS) – 10.04 Edition 6-381
Stop
The "Readout" window displays the name of the program that has just
been read out and the number of bytes transferred.
Press the "Stop" softkey if you want to interrupt data transfer.
Then press the "Start" softkey again to restart data transfer.
Importing a program
Open the Program Manager.
Continue
>
Read in
Select the "Continue" and "Read in" softkeys.
RS-232
settings
Press the "RS-232 settings" softkey to set up the interface.
Enter the desired settings.
Press the "Back" softkey.
The settings for the interface are saved.
On the partner system, select the programs that you want to read
in.
Start the transfer on the partner system.
Start
Press "Start" softkey.
The "Read in" window displays the name of the program that has just
been read in and the number of bytes transferred. The program is
stored in the directory specified in the program header.
Stop
Press the "Stop" softkey if you want to interrupt data transfer.
Then press the "Start" softkey again to restart data transfer.

Table of Contents

Other manuals for Siemens SINUMERIK 840D

Related product manuals