Positional Data
3.6 Zero offset frame, (G54 to G57, G505 to G599, G53, G500/SUPA)
Fundamentals
Programming Manual, 11/2006, 6FC5398-1BP10-2BA0
101
<
;
*
*
*
<
0
;
0
<
;
<
;
75$16;0
N10 G0 G90 X10 Y10 F500 T1
;Approach
N20 G54 S1000 M3
;Call the first zero offset,
;spindle clockwise
N30 L47
;Run program, in this case as a subprogram
N40 G55 G0 Z200
;Call the second zero offset
;Z via obstacle
N50 L47
;Run program as subprogram
N60 G56
;Call third zero offset
N70 L47
;Run program as subprogram
N80 G53 X200 Y300 M30
;Suppress zero offset, ;end of program
Description
Setting the offset values
On the operator panel or universal interface, enter the following values in the internal control
zero offset table:
• Coordinates for the offset
• Angle for rotated clamping and
• Scale factors if necessary
To Next Page
Loading...
