Frames
6.4 Programmable rotation (ROT, AROT, RPL)
Fundamentals
244 Programming Manual, 11/2006, 6FC5398-1BP10-2BA0
Plane change
Warning
If you program a change of plane (G17 to G19) after a rotation, the angles of rotation
programmed for the axes are retained and continue to apply in the new working plane. It is
therefore advisable to deactivate the rotation before a change of plane.
Deactivate rotation
For all axes: ROT (without axis parameter)
Caution
In both cases, all frame components of the previously programmed frame are reset.
To Next Page
Loading...
