Frames
6.4 Programmable rotation (ROT, AROT, RPL)
Fundamentals
Programming Manual, 11/2006, 6FC5398-1BP10-2BA0
245
Substituting statement, ROT X Y Z
The coordinate system is rotated through the programmed angle around the specified axes.
The center of rotation is the last specified settable zero offset (G54 to G599).
Caution
The ROT command cancels all frame components of the previously activated programmable
frame.
;
<
Note
A new rotation based on existing frames is programmed with AROT.
To Next Page
Loading...
