Tables
12.3 List of G functions/preparatory functions
Fundamentals
Programming Manual, 11/2006, 6FC5398-1BP10-2BA0
489
Group 37: Feed profile
Name No. Meaning X m/n SAG MM
FNORM # 1. Feed normal: Feed normal (as per DIN 66025) m Def.
FLIN # 2. Feed linear: Feed linear variable m
FCUB # 3. Feed cubic: Feedrate variable according to cubic spline m
Group 38: Assignment of high-speed inputs/outputs for punching/nibbling
Name No. Meaning X m/n SAG MM
SPIF1 # 1. Stroke/punch interface 1: fast NCK inputs/outputs for punching/nibbling
byte 1
m Def.
SPIF2 # 2. Stroke/punch interface 2: fast NCK inputs/outputs for punching/nibbling
byte 2
m
Group 39: Programmable contour accuracy
Name No. Meaning X m/n SAG MM
CPRECOF 1. Contour precision OFF: Programmable contour precision OFF m Def.
CPRECON 2. Contour precision ON: Programmable contour precision ON m
#The keyword is not valid for SINUMERIK NCU571.
Group 40: Tool radius compensation constant
Name No. Meaning X m/n SAG MM
CUTCONOF 1. Constant radius compensation OFF m Def.
CUTCONON 2. Constant radius compensation ON m
Group 41: Interrupt thread cutting
Name No. Meaning X m/n SAG MM
LFOF 1. Interrupt thread cutting OFF m Def.
LFON 2. Interrupt thread cutting ON m
Group 42: Toolholder
Name No. Meaning X m/n SAG MM
TCOABS 1. Tool Carrier Orientation Absolute: Toolholder orientation absolute m Def.
TCOFR 2. Toolholder orientation frame alignment of tool on
Z axis
m
TCOFRZ 3. Orientable toolholder frame-related (tool on Z axis) m
TCOFRY 4. Orientable toolholder frame-related (tool on Y axis) m
TCOFRX 5. Orientable toolholder frame-related (tool on X axis) m
To Next Page
Loading...
