Tables
12.3 List of G functions/preparatory functions
Fundamentals
488 Programming Manual, 11/2006, 6FC5398-1BP10-2BA0
G824 # 5. OEM - G function
G825 # 6. OEM - G function
G826 # 7. OEM - G function
G827 # 8. OEM - G function
G828 # 9. OEM - G function
G829 # 10. OEM - G function
Two G groups are reserved for the OEM. This enables the OEM to program functions that
can be customized.
Group 33: Settable fine tool offset
Name No. Meaning X m/n SAG MM
FTOCOF # 1. Fine tool offset compensation OFF: Online fine tool offset OFF m Def.
FTOCON # 2. Fine tool offset compensation ON: Online fine tool offset ON X m
Group 34: Smoothing, tool orientation
Name No. Meaning X m/n SAG MM
OSOF # 1. Tool orientation smoothing OFF m Def.
OSC # 2. Continuous tool orientation smoothing m
OSS # 3. Tool orientation smoothing at end of block m
OSSE # 4. Tool orientation smoothing at start and end of block m
OSD # 5 Block-internal rounding with specification of path length m
OST # 6 Block-internal rounding with specification of angle tolerance m
Group 35: Punching and nibbling
Name No. Meaning X m/n SAG MM
SPOF# 1. Stroke/punch OFF: Stroke OFF, nibbling, punching OFF m Def.
SON # 2. Stroke ON: Nibbling ON m
PON # 3. Punch ON: Punching ON m
SONS # 4. Stroke ON slow: Nibbling ON in IPO cycle X m
PONS # 5. Punch ON slow: Punching ON in IPO cycle X m
Group 36: Punching with delay
Name No. Meaning X m/n SAG MM
PDELAYON
#
1. Punch with delay ON: Punching with delay ON m Def.
PDELAYOF
#
2. Punch with delay OFF: Punching with delay OFF m
# The keyword is not valid for SINUMERIK 810D/NCU571.
To Next Page
Loading...
