EasyManua.ls Logo

Siemens siprotec 7SA522 - Page 422

Siemens siprotec 7SA522
628 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Control During Operation
7-14 7SA522 Manual
C53000-G1176-C119-2
From the
Device Front
With a device ready for operation, first press the key. The 0$,10(18 appears.
Use the key to select the menu item 0HDVXUHPHQW, and switch to the list of meas-
ured values using the key. The 0($685(0(17 selection appears. See figure 7-16.
.
Figure 7-16 Selection of measured values on the front — example
The measured values are divided into the following groups:
01 2SHUDWLRQSUL Operating measured values, primary.
03 ,PSHGDQFH3ULP Primary operating impedance.
11 2SHUDWLRQVHF Operating measured values, secondary.
13 ,PSHGDQFH6HF Secondary operating impedance;
Table 7-1 Operational measured values
Measured values
primary secondary % referred to
I
L1
, I
L2
, I
L3
phase currents A A rated operational current
1
)
3I
0
earth currents A A rated operational current
1
)
I
1
, I
2
pos. and neg. seq. currents A A rated operational current
1
)
3I0
sen
sensitive earth current A mA rated operational current
1
)
3
)
I
Y
, I
P
transformer star point current or
earth current in the parallel line
A A rated operational current
1
)
3
)
U
L1–L2
, U
L2–L3
, U
L3–L1
line voltages kV V rated operational voltage
2
)
U
L1–E
, U
L2–E
, U
L3–E
phase-earth voltages kV V rated operational voltage /3
2
)
3U
0
displacement voltage kV V rated operational voltage ·3
2
)
4
)
U
X
voltage at the measuring input U
4
kV V rated operational voltage /3
2
)
U
1
, U
2
pos. and neg. seq. voltages kV V rated operational voltage /3
2
)
R, X operational resistance, reactance ΩΩ
S, P, Q apparent, real, and reactive power MVA, MW,
MVAR
3·U
N
·I
N
rated operational values
1
)
2
)
cos
ϕ power factor (abs) (abs)
f frequency Hz Hz rated frequency
1
) acc. to address  (refer to Sub-section 6.1.3)
2
) acc. to address (refer to Sub-section 6.1.3)
3
) with consideration of the factor  ,,SK&7 (refer to Sub-section 6.1.1)
4
) with consideration of the factor  8SK8GHOWD (refer to Sub-section 6.1.1)
MENU
Etc.
0$,10(18

$QQXQFLDWLRQ²!
!0HDVXUHPHQW²!
0($685(0(17

!2SHUDWLRQSUL
!2SHUDWLRQVHF

Table of Contents

Other manuals for Siemens siprotec 7SA522

Related product manuals