Mounting and dismantling
4.4 Installing, mounting and removing the 3RW5 HMI
SIRIUS 3RW52 Soft Starter
68 Equipment Manual, 04/2020, A5E35630451002A/RS-AE/005
Procedure with door mounting kit IP65
Ⴠ Remove the protective film from the adhesive tape on the seal and secure the seal on the
rear side of the 3RW5 HMI High Feature
.
Ensure that the seal does not overlap.
Ⴠ Place the 3RW5 HMI High Feature in the cutout of the control cabinet door
ཱ.
Ⴠ Continue to screw the screws into the fixing brackets
ི until they protrude approx. 8 mm
at the front. Fasten the fixing brackets onto the 3RW5 HMI High Feature
ཱི.
Ⴠ Tighten the 3RW5 HMI High Feature with a tightening torque of 0.3 ... 0.35 Nm
ུ.
Ensure that all of the screw heads are in contact with the fixing bracket.
To Next Page
Loading...
