Parameter assignment
6.1 Setting elements on the 3RW52 soft starter
SIRIUS 3RW52 Soft Starter
98 Equipment Manual, 04/2020, A5E35630451002A/RS-AE/005
MODE key
x Parameterization of RESET MODE
x Deactivation / activation of Soft torque
x Parameterization of ON / RUN relay output
x Parameterization of the response to bus errors
x Restoring factory setting
Scale of rated operational current I
e
of the motor
You will also find the applicable scale in the Technical data (Page 207).
RESET / TEST key
x Acknowledges faults
x Performing the self-test (user-test)
x Parameterization of ON / RUN relay output
x Parameterization of the response to bus errors
x Restoring factory setting
Requirements
Ⴠ Flat-bladed screwdriver or cross-tip screwdriver PZ1
Procedure
Ⴠ Insert the flat-bladed screwdriver in the opening of the setting element.
Ⴠ Turn the flat-bladed screwdriver until the arrow of the setting element points to the
required parameter setting.
To Next Page
Loading...
