Siemens SISTORE MX User Manual

Getting started
33
Siemens Building Technologies
Fire Safety & Security Products 01.2008
Various status displays
The section below the LEDs indicating the status of the alarm outputs contains
various status displays. The meaning of these status displays is as follows:
No recording at the moment
Min. one camera is recording
No movement
Movement detected
No alarm
Alarm
Camera connection OK
Loss of video
Tampering detected
Tampering and a camera breakdown detected
System condition OK
System error
No active connection to a SISTORE MX client
Connection to a SISTORE MX client is online
Tab. 3 Meaning of the status displays
If the mouse indicator rests on a status display, a Quickinfo window pops up.
Indication of the free hard disk capacity
Underneath the status displays, there is a graphic display of the available capacity
of the hard disks enabled for recording.
Fig. 11 Indication of the free hard disk capacity
NOTE
When the system is not recording, e.g. in the configuration mode, the display shows the hard disk
capacity that is actually engaged and the free hard disk capacity.
When the recording operation is started, the system reserves additional hard disk capacity for about 1-
2 minutes; the percentage of the engaged hard disk capacity will therefore be slightly increased.
If the mouse indicator rests on the hard disk capacity display, a Quickinfo window
pops up.

Siemens SISTORE MX Specifications

General

Brand	Siemens
Model	SISTORE MX
Category	DVR
Language	English