Siemens SITRANS FS230 - Connecting channels 5 and 6 (internal DSL only)

Con󹪝guration Software con󹪝guration Channel 
2 3 4
Relay output
Normally open
Alarm class
Alarm item
NAMUR status signals
 X X 
8
H[W
+
-
ChXC
ChX+
ChX-
Normally open
Relay output
Normally
closed
Alarm class
Alarm item
NAMUR status signals
 X X 
8
H[W
+
-
ChXC
ChX+
ChX-
Normally closed
4.7.7 Connecting channels 5 and 6 (internal DSL only)
Connecting RTD (Resistance Temperature Detector) cable
Perform the following steps for each RTD cable.
1. Loosen the four lid screws and open lid.
2. Remove cap and ferrule from cable gland and slide onto cable.
3. Remove one of the blind plugs (④ or ⑤) and 󹪝t cable gland.


4. Push cable through gland opening.
Connecting
4.7Connecting wall mount enclosure
SITRANS FS130 & FS230
Compact Operating Instructions, 12/2023, A5E38755607-AF 79