Siemens SITRANS FS230 - Device startup

5.4 Device startup
Condition
You have read the Basic Safety Notes (Page85).
Procedure
1. Power-on the device.
For an initial startup, prompts for each of the following steps appear after power-on.
2. Set the language.
The 󹪝rst time the device is con󹪝gured, you will be prompted to set the language. The
parameter "Language" always appears in English. To change the language again (after initial
setup), see parameter Language in FST030 HMI export in SIOS (
https://
support.industry.siemens.com/cs/document/109793928).
3. Set the date and time.
The correct date and time should be set prior to con󹪝guring the device.
4. Run the "Quick commissioning wizard".
Essential parameters should be considered before using the device for the 󹪝rst time.
For any subsequent startup, after power-on, the device automatically starts in operation
view. A transition screen showing 󹪝rst the Siemens logo and then the current 󹪝rmware
revision of the product is displayed while the 󹪝rst measurement is being processed.
Commissioning
5.4Device startup
SITRANS FS130 & FS230
Compact Operating Instructions, 12/2023, A5E38755607-AF 89