Page 4 SITRANS LUT400 (HART) – OPERATING INSTRUCTIONS A5E33329501
mmmmm
Safety Notes
FCC Conformity
US Installations only: Federal Communications Commission (FCC) rules
CE Electromagnetic Compatibility (EMC) Conformity
This equipment has been tested and found to comply with the following EMC Standards:
WARNING: Changes or modifications not expressly approved by
Siemens could void the user’s authority to operate the equipment.
Notes:
• This equipment has been tested and found to comply with the limits for a Class A
digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference when the equipment is
operated in a commercial environment.
• This equipment generates, uses, and can radiate radio frequency energy and, if not
installed and used in accordance with the instruction manual, may cause harmful
interference to radio communications. Operation of this equipment in a residential
area is likely to cause harmful interference to radio communications, in which case
the user will be required to correct the interference at his own expense.
EMC Standard Title
CISPR 11:2004/EN 55011: 2009, CLASS A
Limits and methods of measurements of radio
disturbance characteristics of industrial, scientific,
and medical (ISM) radio-frequency equipment.
EN 61326-1: 2006
IEC 61326-1: 2005
Electrical Equipment for Measurement, Control and
Laboratory Use – Electromagnetic Compatibility.
EN61000-3-2: 2006
Electromagnetic Compatibility (EMC) Part 3-2: Limits
for harmonic current emissions (equipment input
current
≤ 16A per phase).
EN61000-3-3: 2008
A1: 2001 + A2: 2005
Electromagnetic Compatibility (EMC) Part 3-3:
Limitation of voltage changes, voltage fluctuations,
and flicker in public low voltage supply systems, for
equipment with rated current
≤ 16A per phase and
not subject to conditional connection.
EN61000-4-2:2009
Electromagnetic Compatibility (EMC) Part 4-2:Testing
and measurement techniques – Electrostatic
discharge immunity test.
EN61000-4-3:2006
Electromagnetic Compatibility (EMC) Part 4-3:
Testing and measurement techniques – Radiated,
radio-frequency, electromagnetic field immunity test.
EN61000-4-4:2004
Electromagnetic Compatibility (EMC) Part 4-4:
Testing and measurement techniques – Electrical
fast transient/burst immunity test.
EN61000-4-5:2006
Electromagnetic Compatibility (EMC) Part 4-5:
Testing and measurement techniques – Surge
immunity test.
To Next Page
Loading...
Need help?
General
