Siemens SITRANS LUT400 Series - DIN-Rail Mount

A5E33329501 SITRANS LUT400 (HART) – OPERATING INSTRUCTIONS Page 15
mmmmm
Installing and Mounting
DIN-rail mount
For a more detailed dimension drawing, see SITRANS LUT400 Dimensions on page 255.
Mounting the enclosure
1. Angle top of enclosure toward DIN-rail, and position slightly above top of rail.
2. Move enclosure downward against DIN-rail to hook clips on back of enclosure to
top of DIN-rail.
3. Press device flush against DIN-rail to engage DIN-rail slide, which will fasten
enclosure securely to DIN-rail.
Please note:
• Recommended mounting: directly to horizontal DIN-rail.
• Required DIN-rail dimensions: TH 35-7.5 or TH 35-15 per standard IEC 60715.
• The DIN-rail MUST be able to support four times the weight of the SITRANS LUT400.
Removing the enclosure
1. From the front of the device, place screwdriver in slot at bottom of DIN-rail slide and
pry downward. This will unclip slide from bottom of DIN-rail.
2. While holding slide down, push upward on enclosure to release clips from top of
DIN-rail.
back of enclosure
DIN-rail
DIN-rail slide
clips (2)
slot