A5E33329501 SITRANS LUT400 (HART) – OPERATING INSTRUCTIONS Page 137
mmmmm
Parameters
Parameter reference (LUI)
Parameters are identified by name and organized into function groups. See
LCD Menu
Structure
on page 277 for a chart.
Parameters accessible via the local push buttons are preceded by a number. Parameters
not preceded by a number are accessible only via remote operation.
Based on model configuration (LUT420, LUT430, LUT440), some parameters will not
appear on LUI. Exceptions are noted by parameter.
Where the same parameter exists for more than one model, but is represented by a
different menu number, both parameters are listed together (separated by "OR"), and the
details are noted under the second of the two parameters.
For more details see:
•
Operation via SIMATIC PDM 6 (HART)
on page 127
•
Operation via AMS Device Manager (HART)
on page 131
1. Wizards
Several Wizards are available with the SITRANS LUT400. Wizards group together all the
settings needed for a particular feature. All Wizards are available via the local push
buttons, and many are also available via SIMATIC PDM under the Device menu.
For details on the Wizards listed below, see
Quick Start Wizards
on page 38 of
Commissioning
.
Notes:
• Parameter names and menu structure are almost identical for SIMATIC PDM
and the local user interface (LUI). Access is described below for some
parameters that do not appear in the SIMATIC PDM menu structure.
(For further details on using these parameters within SIMATIC PDM, see the
LUT400 Communications manual
a
.)
• Default settings in the parameter tables are indicated with an asterisk (*)
unless explicitly stated.
• Parameter range values are displayed in the default of the defined unit of
measure. For example, if a parameter description states that it is
defined in
Units (2.1.1.)
, the range for that parameter will be shown in meters [as meters
(M) is the default for Units (2.1.1.)].
• The number of decimals displayed for a parameter value will depend on the
unit of measure, unless decimal places can be set by the user (e.g. Totalizers -
2.7.3.2.Totalizer Decimal Position
).
For example:
Values defined in default
2.1.1.Units
will display 3 decimal places; default
2.6.2.Volume Units
- 1 decimal place, default
2.15.3.7.Flowrate Units
- 0 decimal
places.
• To enter Program mode using the local push buttons, press . Press to
return to Measurement mode.
a.
Communications for SITRANS LUT400 (HART) Manual (7ML19985NE01)
To Next Page
Loading...
