A5E33329501 SITRANS LUT400 (HART) – OPERATING INSTRUCTIONS Page 125
mmmmm
General Operation
Burst mode
SITRANS LUT400 does not support burst mode.
HART multi-drop mode
HART Multi-drop Mode allows the connection of multiple field devices via HART. To setup
a device in Multi-drop Mode, see
Device Address
on page 126. Details on the use of
Multi-drop Mode are outlined in an application guide
Working with HART
, which can be
downloaded from the product page of our website. Go to:
www.siemens.com/sitransLUT400 under Support and click on Application Guides.
SIMATIC PDM
This software package is designed to permit easy configuration, monitoring, and
troubleshooting of HART devices. The HART EDD for SITRANS LUT400 was written with
SIMATIC PDM in mind and has been extensively tested with this software.
For more information, see
Operation via SIMATIC PDM 6 (HART)
on page 127.
HART Electronic Device Description (EDD)
In order to configure a HART device, the configuration software requires the HART
Electronic Device Description for the instrument in question.
You can download the HART EDD for SITRANS LUT400 from the product page of our
website. Go to: www.siemens.com/sitransLUT400
and click on Support>Software
Downloads.
Older versions of the library will have to be updated in order to use all the features of
SITRANS LUT400.
HART Status
Information on HART Status is outlined in an application guide
Working with HART
, which
can be downloaded from the product page of our website. Go to:
www.siemens.com/sitransLUT400 under Support and click on Application Guides.
LUT400 Communication connections
The SITRANS LUT400 can be connected to a computer system via a HART modem (connected
to the mA OUT/HART terminal block), or directly connected via a Universal Serial Bus (USB)
cable (for use with the Web Browser interface). A HART network requires a device address be
configured. For communications via USB, connect SITRANS LUT400 to your computer via the
USB cable.
To Next Page
Loading...
