Page 154 SITRANS LUT400 (HART) – OPERATING INSTRUCTIONS A5E33329501
mmmmm
Parameters
2.7.2. Modifiers
2.7.2.1. Wall Cling Reduction
2.7.2.1.1. Enable
Enables/disables 2.7.2.1.2.Level Setpoint Variation.
2.7.2.1.2. Level Setpoint Variation
Varies the ON and OFF setpoints to reduce material buildup on the
walls (defined in 2.1.1. Units).
This value is the range in which the setpoints are allowed to deviate.
The pump ON and OFF Setpoint values are randomly varied inside
the range to ensure that the material level does not consistently
stop at the same point.
Note: Default settings in the parameter tables are indicated with an asterisk
(*) unless explicitly stated.
Options
ENABLED
*
DISABLED
Values
Range: 0.000 to 99999.000
Default: 0.000
level setpoint ON
level setpoint variation
level setpoint OFF
random setpoint range
To Next Page
Loading...
