Siemens SITRANS LUT400 Series - Page 509

Page 196 SITRANS LUT400 (HART) – OPERATING INSTRUCTIONS A5E33329501
mmmmm
Parameters
Supported PMDs (cont’d)
Trapezoidal Flume BS-3680
2.15.4.5. OCM Dimension 1 - approach width B
2.15.4.6. OCM Dimension 2 - throat width b
2.15.4.7. OCM Dimension 3 - hump height p
2.15.4.8. OCM Dimension 4 - throat length L
2.15.4.3. Slope
U-Flume BS-3680
2.15.4.5. OCM Dimension 1 - approach diameter Da
2.15.4.6. OCM Dimension 2 - throat diameter D
2.15.4.7. OCM Dimension 3 - hump height p
2.15.4.8. OCM Dimension 4 - throat length L
Finite Crest Weir BS-3680
2.15.4.5. OCM Dimension 1 - crest width b
2.15.4.6. OCM Dimension 2 - crest height p
2.15.4.7. OCM Dimension 3 - crest length L
Thin Plate Rectangular Weir BS-3680
2.15.4.5. OCM Dimension 1 - approach width B
2.15.4.6. OCM Dimension 2 - crest width b
2.15.4.7. OCM Dimension 3 - crest height p
Thin Plate V-Notch Weir BS-3680
2.15.4.2. V-Notch Angle
Rectangular Weir Contracted
2.15.4.5. OCM Dimension 1 - crest width b
Round Pipe
2.15.4.5. OCM Dimension 1 - pipe inside diameter D
2.15.4.3. Slope
2.15.4.4. Roughness Coefficient