Siemens SITRANS LUT400 Series - Page 594

A5E33329501 SITRANS LUT400 (HART) – INSTRUCTION MANUAL SITRANS LUT400 (HART) – INSTRUCTION MANUAL Page 281
Appendix C: menu chart
2.14.3 DAYLIGHT SAVING
2.14.3.1 ENABLE
2.14.3.2 STARTING ORDINAL
2.14.3.3 STARTING DAY
2.14.3.4 STARTING MONTH
2.14.3.5 ENDING ORDINAL
2.14.3.6 ENDING DAY
2.14.3.7 ENDING MONTH
2.15 FLOW (LUT430, 440 only)
2.15.1 PRIMARY MEASURING DEVICE
2.15.2 AUTO ZERO HEAD
2.15.3 BASIC SETUP
2.15.3.1 METHOD OF FLOW CALCULATION
2.15.3.2 FLOW EXPONENT
2.15.3.3 MAXIMUM HEAD
2.15.3.4 MAXIMUM FLOW AT 20MA
2.15.3.5 ZERO HEAD OFFSET
2.15.3.6 FLOWRATE DECIMAL
2.15.3.7 FLOWRATE UNITS
2.15.3.8 USER DEFINED UNIT
2.15.3.9 LOW FLOW CUTOFF
2.15.4 PMD DIMENSIONS
2.15.4.1 K FACTOR
2.15.4.2 V NOTCH ANGLE
2.15.4.3 SLOPE
2.15.4.4 ROUGHNESS COEFFICIENT
2.15.4.5 OCM DIMENSION 1
2.15.4.6 OCM DIMENSION 2
2.15.4.7 OCM DIMENSION 3
2.15.4.8 OCM DIMENSION 4
2.15.5 UNIVERSAL HEAD VS FLOW
2.15.5.1 TABLE 1-8
2.15.5.2 TABLE 9-16
2.15.5.3 TABLE 17-24
2.15.5.4 TABLE 25-32
2.16 TOTALIZERS (LUT430, 440 only)
2.16.1 DAILY TOTALIZER
2.16.2 RUNNING TOTALIZER
2.16.3 TOTALIZER DECIMAL POSITION
2.16.4 TOTALIZER MULTIPLIER
2.16.5 RESET DAILY TOTALIZER
2.16.6 RESET RUNNING TOTALIZER
3. MAINTENANCE AND DIAGNOSTICS
3.1 IDENTIFICATION
3.1.1 TAG
3.1.2 LONG TAG
3.1.3 DESCRIPTOR
3.1.4 MESSAGE
3.1.5 INSTALLATION DATE
3.1.6 PRODUCT
3.1.7 ORDER NO.
3.1.8 SERIAL NUMBER
3.1.9 FINAL ASSEMBLY NUMBER
3.1.10 HARDWARE REV
3.1.11 FIRMWARE REV
3.1.12 LOADER REV
3.1.13 MANUF. DATE
3.1.14 ORDER OPTION
3.2 DIAGNOSTICS
3.2.1 ECHO PROFILE
3.2.2 TREND
3.2.3 MASTER RESET
3.2.4 POWER-ON RESETS
3.2.5 POWER-ON TIME
3.2.6 VIEW LOGS
3.2.6.1 ALARMS
3.2.6.2 OCM
3.2.6.3 DAILY TOTALS
3.2.6.4 PV
3.2.7 PUMP RECORDS
3.2.7.1 RUN TIME RELAY 2
3.2.7.2 RUN TIME RELAY 3
3.2.7.3 RELAY PUMP 1
3.2.7.4 RELAY PUMP 2
3.2.8 TEMPERATURE PEAK VALUES
3.2.8.1 HIGHEST VALUE
3.2.8.2 LOWEST VALUE
3.2.9 ECHO QUALITY
3.2.9.1 FIGURE OF MERIT
3.2.9.2 CONFIDENCE
3.2.9.3 ECHO STRENGTH
3.2.9.4 NOISE AVERAGE
3.2.9.5 NOISE PEAK
3.3 MAINTENANCE
3.3.1 TRANSDUCER ENABLE
3.3.2 BACKUP CONTROL
3.3.3 REMAIN. DEV. LIFE
3.3.3.1 LIFETIME EXPECTED
3.3.3.2 TIME IN OPER.
3.3.3.3 REMAIN. LIFETIME
3.3.3.4 REMINDER ACTIV.
3.3.3.5 REMIND. 1 (REQ.)
3.3.3.6 REMIND. 2 (DEM.)
3.3.3.7 MAINT STAT
3.3.3.8 ACK STATUS
2. SETUP - DATE AND TIME (cont’d)