Siko AG05 - Page 39

Service Protocol
AG05 Date: 15.06.2016 Art. No. 85677 Mod. status 139/16 Page 39 of 64
Command
Length
Reply
Description
yy = 32: Decimal places
0 = 0
1 = 0.0
2 = 0.00
3 = 0.000
4 = 0.0000
(see chapter 8: Parameter description  Parameter no.
42)
yy = 33: Direction indication function
0 = On
1 = inverted
2 = Off
(see chapter 8: Parameter description  Parameter no.
44)
yy = 34: Encoder resolution (see chapter 8: Parameter
description  Parameter no. 72)
yy = 35: reserved
yy = 36: LED 2 orange
0 = Off
1 = On
(see chapter 8: Parameter description  Parameter no.
39)
yy = 37: LED1 red
0 = Off
1 = On
(see chapter 8: Parameter description  Parameter no.
40)
yy = 38: LED1 green
0 = Off
1 = On
(see chapter 8: Parameter description  Parameter no.
41)
yy = 39: Inching mode 2 acceleration type
0 = static acceleration
1 = incremental acceleration
(see chapter 8: Parameter description  Parameter no.
31)
yy = 40: Protocol
0 = SIKONETZ5
1 = Service protocol
(see chapter 8: Parameter description  Parameter no.
34)
yy = 41: PIN change (see chapter 8: Parameter
description  Parameter no. 48)
yy = 42: Temporary key function enable
0 = Access as defined under Key function enable
1 = Access inverted as defined under Key function
enable