Silvercrest 274313 - Cleaning and Care

GB
│
IE
│
13 ■
SBB 850 B1
■ If a new programme cannot be started directly
after the bread maker has completed a baking
process, it means the appliance is still too hot.
In this case, the display panel reverts to the
default setting (programme 1). Open the ap-
pliance lid 2 and allow the machine to cool
down for 20 minutes before reusing it.
NOTE
► Do not attempt to reuse the appliance until it
has cooled itself down. This functions only in
progr
amme 12.
■ If "EE0", "EE1" or "LLL" appears on the display
after the progr
amme has started, switch the
bread maker off and then on again by removing
the plug from the socket and then putting it
back in. If the failure display persists, contact
Customer Service.
Cleaning and care
DANGER! ELECTRIC SHOCK!
► Before cleaning the appliance, always remove
the plug from the socke
t and allow the appli-
ance to cool down completely.
Protect the appliance from moisture, as
this can lead to electric shock. Please also
observe the safety instructions.
CAUTION! MATERIAL DAMAGE!
► The appliance and its accessories are not
dishwasher-pr
oof!
► Do not use any chemical cleaning agents or
solvents to clean the bread mak
er.
Housing, lid, baking chamber
■ Remove all residues from the inside of the
baking chamber using a w
et cloth or a slightly
damp sof
t sponge.
■ Wipe both the housing and the lid also only
with a moist cloth or sponge.
For easier cleaning, the appliance lid 2 can be
removed from the housing:
– Open the appliance lid 2 until the plastic
pegs fi
t thr
ough the openings of the hinge
guides.
– Pull the appliance lid 2 out of the hinge
guides.
■ To replace the appliance lid 2 after cleaning,
guide the plastic locking tabs through the opening
of the hinge guides.
■ Dry everything thoroughly and make sure that
all parts are dry before reuse.
Baking mould, kneading blades and
accessories
CAUTION! MATERIAL DAMAGE!
► Never immerse the baking mould 7 in water
or other liquids.
► The sur
faces of the baking mould 7 and the
kneading blades 6 are coated with a non-
stick coating. When cleaning the appliance,
do not use aggressiv
e detergents, abrasive
cleaning agents or objects that may cause
scratches to the surfaces.
NOTE
► Due to moisture and vapours, the surfaces of
various parts may change in their appear
-
ance over the course of time. This has no
infl uence on the function nor does it reduce
the quality of the baking results.
IB_274313_SBB850B1_LB3.indb 13 18.02.16 15:15