EasyManuals Logo

Simplex 4010ES User Manual

Simplex 4010ES
58 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #29 background imageLoading...
Page #29 background image
4-4
Acknowledging Supervisory Conditions, Continued
Individually
Acknowledging
Supervisory
Conditions
2. Press the SUPV ACK key. Repeat this step and read the display. The alphanumeric display shows
the area and type of condition.
a. The tone-alert silences and the LED glows steady.
b. The display shows the area and type of problem.
3. Read the alphanumeric display. Investigate the problem to determine its cause. Restore or
replace the defective device (switch, wire, notification appliance) in accordance with the
manufacturers instructions, or call SimplexGrinnell to repair the system.
When the problem causing the condition is corrected, the SUPERVISORY LED flashes and the
tone-alert sounds steady.
4. Press the SUPV ACK key. The display shows the system status.
5. Press the SUPV ACK key again. After a short delay, the display indicates that the system is
normal.

Table of Contents

Other manuals for Simplex 4010ES

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Simplex 4010ES and is the answer not in the manual?

Simplex 4010ES Specifications

General IconGeneral
Control Panel TypeAddressable Fire Alarm Control Panel
DisplayLCD
Operating Temperature32°F to 120°F (0°C to 49°C)
Power Supply120V AC or 240V AC
Zones10
Communication PortsRS-232, Ethernet
Signaling Line Circuits (SLCs)2
Notification Appliance Circuits (NACs)4
Max Notification AppliancesVaries based on NAC configuration and power supply
Communication OptionsCellular, Ethernet
Weight30 lbs
Humidity RangeUp to 93% non-condensing
CertificationsUL, FM, CSFM, MEA
Network CapabilityYes

Related product manuals