Simplex 4010ES User Manual

6-2
Logging In and Out of the System
Introduction The 4010ES system uses four access levels, referred to by the numbers one through four, to control
what system operators can do with the system. The system typically operates at access level one,
which allows an operator to accomplish basic tasks (for example, acknowledge alarm, trouble, and
supervisory conditions) without logging in to the system.
Other functions – for example, the use of the user-defined function keys – are passcode protected to
prevent access by unauthorized personnel.
Log In Procedure Follow these steps to log in to the system at access level two, three, or four. The keypad used to enter
the passcode is located behind the interface panel access door.
1. Obtain the passcode for the access level at which you want to operate.
2. Press the Menu key. The alphanumeric display shows the following message.
3. Press the ENTER key on the Entry keypad. The following message displays:
4. Press the 1 key on the Entry keypad. The display shows the following message.
5. Enter the passcode for the access level. The passcode can be up to 10 numbers in length. Press
the ENTER key on the Entry keypad when you have finished entering the code. An X is
displayed for each digit of your passcode, as shown below.
Continued on next page

Simplex 4010ES Specifications

General

Control Panel Type	Addressable Fire Alarm Control Panel
Display	LCD
Operating Temperature	32°F to 120°F (0°C to 49°C)
Power Supply	120V AC or 240V AC
Zones	10
Communication Ports	RS-232, Ethernet
Signaling Line Circuits (SLCs)	2
Notification Appliance Circuits (NACs)	4
Max Notification Appliances	Varies based on NAC configuration and power supply
Communication Options	Cellular, Ethernet
Weight	30 lbs
Humidity Range	Up to 93% non-condensing
Certifications	UL, FM, CSFM, MEA
Network Capability	Yes