3-4
Acknowledging Troubles
Globally
Acknowledging
Troubles
If global acknowledge is enabled on the 4010ES, the system automatically clears after the source of
the trouble clears. Approximately 30 seconds after the source of the trouble clears, the alphanumeric
display should indicate a normal system.
To globally acknowledge trouble points, follow these steps:
1. Unlock and open the enclosure door. The alphanumeric display shows the trouble condition. For
example:
Globally Acknowledging Troubles
2. Press the TROUBLE ACK key under the flashing yellow LED. The alphanumeric display shows
the area and type of trouble. The tone-alert silences and the yellow LED glows steady.
3. Read the alphanumeric display and investigate the area to determine the cause of the trouble.
a. Restore or replace the defective device (switch, wire, notification appliance, etc.) in
accordance with the device’s instructions.
b. The trouble condition automatically clears when the problem has been corrected.
c. After a delay, the alphanumeric display reads:
Individually
Acknowledging
Troubles
When individual acknowledge is used, the tone-alert re-sounds when the condition clears. Individual
acknowledge must be selected if the panel is providing proprietary receiving service in accordance
with NFPA72. Follow these steps to use individual acknowledge.
1. Unlock and open the enclosure door. The alphanumeric display shows the trouble condition. For
example:
To Next Page
Loading...
Need help?
General
