Simplex 4010ES User Manual

6-10
Printing Reports, Continued
Overview
Procedure 1. Press the Menu key. Use the Next and Previous keys to scroll through the choices until the
“PRINT REPORTS?” choice is displayed.
2. Use the Next and Previous keys to scroll through the categories of report (Alarm History, Trouble
History, etc.).
3. When the category of report you want to print is displayed, press ENTER. The system prompts
you to confirm that you want to generate the report. Press ENTER again.
Table 6-1. Reports (continued)
Report Description
TrueAlert Status Report
This report can be created after the TrueNAC Voltage
Drop Test (see Chapter 7) is run. It reports the following
information for each Multi Candela TrueAlert Device.
•Point ID.
• Custom Label.
• Pass/Fail.
Report the following information for each SLC
• Nominal Current (A) - The current draw on the
TrueAlert circuit when the test was run.
• Worst Case Current (A) - The current draw on the
SLC under worst case operating conditions.
• Worst Case voltage Above/Below threshold (V).
TrueAlarm CO Report
This report provides the following information regarding
the CO devices:
• Device Number (on the network).
• Custom Label (custom description of device).
• Current Device Value (PPM).
• End-of-Life Date.
• Device Status (Normal, Trouble).

Simplex 4010ES Specifications

General

Control Panel Type	Addressable Fire Alarm Control Panel
Display	LCD
Operating Temperature	32°F to 120°F (0°C to 49°C)
Power Supply	120V AC or 240V AC
Zones	10
Communication Ports	RS-232, Ethernet
Signaling Line Circuits (SLCs)	2
Notification Appliance Circuits (NACs)	4
Max Notification Appliances	Varies based on NAC configuration and power supply
Communication Options	Cellular, Ethernet
Weight	30 lbs
Humidity Range	Up to 93% non-condensing
Certifications	UL, FM, CSFM, MEA
Network Capability	Yes