Simplex 4010ES User Manual

5-1
Chapter 5
Selecting Points for Status and Control
Introduction Many of the advanced operations that can be accomplished from the operator interface first require
you to select the point on which you want to perform the operation. Points can be selected in one of
three ways.
• Alarm, Trouble, Supervisory List. Points that are reporting an alarm, trouble, or
supervisory condition can be selected from the active alarm, trouble, or supervisory list.
• Using the Menu. The menu system includes an option that allows you to scroll through each
category (monitor, signal, etc.) of point, and then after selecting a category, you can scroll
through the points for the category.
• Using the Entry Keys. The Entry keys, located on the far right of the operator interface,
contain abbreviated labels for each category of point. (For example, the key in the upper left
corner of the Entry keys is labeled “ZONE” and the key to its right is labeled “SIG.” Pressing
one of these keys causes the system to prompt you to select a specific point within the selected
category.
In this Chapter Refer to the page number listed in this table for information on a specific topic.
Topic See Page #
Selecting Points from Alarm, Trouble, Supervisory List 5-2
Selecting Points from the Menu 5-3
Selecting Points with the Entry Keypad 5-4

Simplex 4010ES Specifications

General

Control Panel Type	Addressable Fire Alarm Control Panel
Display	LCD
Operating Temperature	32°F to 120°F (0°C to 49°C)
Power Supply	120V AC or 240V AC
Zones	10
Communication Ports	RS-232, Ethernet
Signaling Line Circuits (SLCs)	2
Notification Appliance Circuits (NACs)	4
Max Notification Appliances	Varies based on NAC configuration and power supply
Communication Options	Cellular, Ethernet
Weight	30 lbs
Humidity Range	Up to 93% non-condensing
Certifications	UL, FM, CSFM, MEA
Network Capability	Yes