3-6
TICs are mounted like any other 4-inch (102 mm) X 5-inch (127 mm) card.
Use the following instructions and Figure 3-2, below, to mount 4”x 5” slave cards to an
expansion bay.
IMPORTANT:
1. Screw two standoffs and washers to the appropriate holes in the back of the
cabinet. These holes must line up with the screwholes in the 4-inch (102 mm) X
5-inch (127 mm) card. See Figure 3-2.
2. Plug the 4-inch (102 mm) x 5-inch (127 mm) card into the PDI connector (P8).
3. Secure the top of the card to the standoffs with two #6 Torx screws and washers.
Figure 3-2. TIC Mounting
Continued on next page
TIC/Riser Mounting (4100ES){xe "transponder interface card (TIC):
mounting"}{xe "mounting: transponder interface card (TIC)"}
Overview
Mounting
Instructions
TIC CARD
STANDOFFS
#6 SCREWS
WASHERS
PDI CONNECTOR
(reverse side)
PDI
SCREW
RETAINERS
To Next Page
Loading...
