Simplicity LEGACY Series - Page 87

7 - 19
7 Electrical System Service
Location and Replacement
Figure 18. PTO Switch Replacement
A Dashboard C. PTO Switch
B. Wire Harness D. Locking Tabs
A
PTO SWITCH
The PTO switch (C, Figure 38) is located in the
dashboard (A) on the right-hand side of the steering
wheel.
1. Disconnect and secure the negative battery cable,
(see Section 6, COMMON SERVICE PROCE-
DURES).
2. Unplug the wire harness (B, Figure 18) from the back
of the switch (C).
3. From behind the dashboard, push in the locking tabs
(D) and remove the switch as shown in Figure 18.
4. Install PTO switch in reverse order of removal.
B
A
C
C
C
HEIGHT OF CUT SWITCH
The height of cut switch is located in the dashboard on
the right-hand side of the steering wheel. The height of
cut switch sends power to the outlet under the left foot
rest.
1. Disconnect and secure the negative battery cable,
(see Section 6, COMMON SERVICE PROCE-
DURES).
2. Unplug the wire harness (B, Figure 17) from the back
of the height of cut switch (C).
3. From behind the dashboard, push in the locking tabs
(D) and remove the switch as shown in Figure 17.
NOTE: Be careful to not press on the tabs that hold the
contact block to the switch rocker. The parts in the con-
tact block are very small and could get lost if separated.
4. Install height of cut switch in reverse order of
removal.
Figure 17. Height of Cut Switch Replacement
A Dashboard C. Height of Cut Switch
B. Wire Harness D. Locking Tabs
B
A
C
D
D
D
D
Not for Reproduction