Setup at installation | 103
Confirm Demo mode by pressing the
softkey. If the
unit is turned off while in demo mode, the demo mode
will still be active on next power on.
Demo mode is deactivated by using the menu as
illustrated above.
The user will be notified with a
‘DEMO’ message every 10
seconds as long as the demo is
running.
If several products are going to operate in Demo mode in
a SimNet system, they should all be set to Demo mode
initially. To have the full benefit of the autopilot in Demo
mode, an Autopilot Computer must be part of the system.
About
By selecting the About menu item, an information
window will display autopilot model, software version
number (1.1.), software release (00) and date of release.
The shown readout is only an example!
To Next Page
Loading...
Need help?
General
