Setup at installation | 85
- Set the trim tabs and stabilizers to have no effect
on the boat’s heading.
- Steer the boat manually on a steady course.
- If required, confirm the rudder ZERO position by
pressing the
softkey.
Compass calibration
Before the compass calibration is started, make sure that
there is enough open water around the vessel to make a
full turn.
The calibration should be done in calm sea conditions and
with minimal wind to obtain good results. Use about 60-
90 seconds to make a full circle.
1. Highlight the Calibrate line in the dialog
2. Begin turning the boat to port or starboard
3. Press the MENU key to start the automatic compass
calibration
To Next Page
Loading...
