70 | Setup at installation
4.2 Installation Menu
The installation settings must be performed as part of the
commissioning of the AP28 system. Failure to do so
correctly may prohibit the AP28 from functioning properly!
The Installation menu can only be accessed in STBY
mode.
The Installation settings are grouped into the following
functional categories:
• Commissioning: Dockside and Seatrial setup
• Automatic steering: Permits viewing and changing of
basic steering parameters (See
also response control on page 21)
• Calibration: Calibration of sensors (also partly
part of Commissioning)
• Boat type: Select boat type (also part of
commissioning)
• Rudder drive: Rudder drive setup (also part of
commissioning)
• SimNet config: SimNet group setup
Each group is designed to focus on specific functions and
enable quick access when changes need to be made.
Some important points regarding the installation settings:
• When the AP28 is delivered from factory AND ANY
TIME AFTER AN AUTOPILOT RESET
HAS BEEN
PERFORMED, the installation settings are all reset to
factory preset (default) values. The automatic
interface prompt will appear (see page
69) and a
complete setup has to be made
• The Seatrial settings are dependent on successful
completion of the Dockside settings
To Next Page
Loading...
Need help?
General
