Simrad GC80 Compact MK2 - Page 106

Simrad GC80/85 Compact MK2 Gyro Compass
988-12718-003 106
Jumper settings on ICNT board
JUMPER DEFAULT FUNCTION DESCRIPTION
J6
(RESET)
Open CPU reset
Used when resetting the CPU
J7
(1TX)
5-6 short
Output serial signal
selection
Output port: “1TX”
3-4 short = IEC61162-2 ed.1 or TOKIMEC version
5-6 short = IEC61162-1 ed.4
(ref. page 13)
NOTE: Never use both jumpers at the same
time!
J8
(2TX)
3-4 short
Output port: “2TX”
1-2 short = IEC61162-2 ed.1 or TOKIMEC version
3-4 short = IEC61162-1 ed.4
(ref. page 13)
NOTE: Never use both jumpers at the same
time!