Simrad HH36 - Settings: COG;SOG (Course & Speed Display Options); GPS Alert

Simrad - HH36 Installation and Operation Instructions32
4-6-6 Settings: COG/SOG (Course & speed display options)
If your position and time data is being updated, you can use COG/SOG to choose whether
to show or hide your course over ground (COG) and speed over ground (SOG) data on the
screen.
Note: Despite the COG/SOG setting, if TIME DISPLAY is ON, the course and speed will not
display on screen.
COG/SOG
►ON
OFF
MENU
BUDDY LIST ▲
CONTRAST
►GPS/DATA ▼
GPS/DATA
MANUAL
►SETUP
SETUP
TIME DISPL▲
LL DISPLY
►COG/SOG ▼
COAST GUARD
356
°
12.6KTS
27
°
34.126’N
109
°
55.568’W
1. Select GPS/DATA, then SETUP.
2. Move the cursor to COG/SOG and push ENTER.
3. Select ON or OFF as desired, In this example, ON has been selected, so the screen
shows the bearing and speed.
If COG/SOG is set on, the time will not display on screen.
4-6-7 GPS alert
You can choose to turn the GPS ALERT on/o.
GPS ALERT
►ON
OFF
MENU SELECT
BUDDY LIST ▲
CONTRAST
►GPS/DATA ▼
GPS/DATA
MANUAL
►SETUP
SETUP
LL DISPLY ▲
COG/SOG
►GPS ALERT ▼
1. Select GPS/DATA, then SETUP.
2. Move the cursor to GPS ALERT and press ENTER.
3. Select ON/OFF as desired, in this example, ON has been selected, so if the GPS signal
is lost, then the NO GPS alert will sound.