Simrad HH36 - DSC Test Reply (TEST REPLY); Set the Inactivity Timer (TIMEOUT)

Simrad - HH36 Installation and Operation Instructions 43
1. Select DSC SETUP, then AUTO SWITCH.
2. Select ON to enable automatic channel switching.
3. Select OFF to disable automatic channel switching.
4-8-7 DSC Test Reply (TEST REPLY)
You can respond to incoming DSC TEST calls with an automatic response or with a
manual response.
• MANUAL manual response is required, press ENTER to conrm or press EXIT to
cancel.
• AUTO automatically replies after a 10 second delay with an ACK to any
incoming DSC TEST call.
DSC SETUP
AUTO SWITC▲
►TEST REPLY
TIMEOUT
TEST REPLY
►AUTO
MANUAL
4-8-8 Set the inactivity timer (TIMEOUT)
You can set the inactivity timer with the following options:
NON AUTO
NO TIMEOUT
►10 MINS
15 MINS
TIMEOUT
AUTOMATED
►NON AUTO
DSC SETUP
AUTO SWITC
▲
TEST REPLY
►TIMEOUT
• AUTOMATED you can set the inactivity timer to automatically timeout after a
period of inactivity for the following two categories: NON-DISTRESS
or DISTRESS
Timeout options are:
DISTRESS: NO TIMEOUT; 5 MINS; 10 MINS (default is NO TIMEOUT)
NON-DISTR: NO TIMEOUT; 10 MINS; 15 MINS (default is 15 MINS)
• NON AUTO you can set the inactivity timer to exit any non-automated
procedure activity.
Timeout options are:
NO TIMEOUT; 10 MINS; 15 MINS (default is 10 MINS)
Note: If NO TIMEOUT is selected, then you must press the EXIT key to exit the procedure.
Example: to set a 10 minute TIMEOUT for non-automated functions:
1. Select TIMEOUT, then select NON AUTO
2. Select desired timeout period: NO TIMEOUT, 10 MINS or 15 MINS