Simrad - HH36 Installation and Operation Instructions64
Section 7 - Installation Instructions
7-1 Batteries and charger
The radio is shipped with a sealed Li-Polymer battery pack that is rechargeable.
WARNING
The charger provided for this radio is only to be used to charge the battery pack
provided. Do not charge any other type of batteries in the charger as re, explosion
or battery damage could occur. Avoiding extreme room temperature will also help
prolong the life of the battery pack for the radio.
7-1-1 Installing the battery pack
1. Position the battery pack to line up the three external alignment tabs to the
alignment slots in the radio.
2. Engage the battery pack into the radio until battery pack is fully seated against the
radio housing.
3. Pivot the locking tab up until it snaps into place on the back of the battery pack.
7-1-2 Initial charge
You can either charge the Li-Polymer battery pack when it is attached to the radio or
separated:
To Next Page
Loading...
Need help?
General
