Cleaning the Feed Bed should be confirmed by pressing “Clean Feed Bed” button. The Feed
Bed will be raised and the Print Bed will be lowered.
All remaining powder from Feed Bed should be placed into the Print Bed. Precisely clean the
Feed Bed from the remaining unsintered powder including the Beds’ surroundings.This can
be done with the use of a spatula.
“Skip” button can be pressed if cleaning process had been previously done.
4. Ensure that the movement path of the Recoater is not obstructed and remove all objects
from the printer chamber.
43 Sinterit Lisa USER MANUAL
To Next Page
Loading...
