Sirona CEREC SpeedFire - Switching the Unit on and off

65 71 165 D3639
D3639.201.01.02.02 10.2016
29
Sirona Dental Systems GmbH 4Transport and commissioning
Operating Instructions CEREC SpeedFire 4.6Commissioning
båÖäáëÜ
4.6.2 Switching the unit ON and OFF
Switch on the unit
1. Use the main switch on the rear of the unit to switch it on.
2. Press the start button on the control panel until the unit’s strip of LEDs
lights up.
 The unit completes a system check and starts the application
software.
Switching the unit off
➢ To switch off the unit again, press and hold the start button on the
control panel for several seconds.
or
➢ You can also use the main switch on the rear of the unit to switch
it off.
Open door
1. Open the door in order to insert the door insulation also supplied.
2. Go to the Settings menu /
"Service" / "open/ close door" , in order to
activate the opening of the door.
3. Close the menu after opening in order to arrive at the main view.
NOTICE
Only switch on the unit once you have connected the network cable.
IMPORTANT
An update process interrupted due to a power failure means that the
control panel will be displayed when the unit is turned on and will
disappear immediately.
➢ In this case, press the Start button (A) on the control panel and keep
this pressed down until a beep sounds on the furnace and the
furnace restarts.
 This process can take 2-3 minutes.