Sirona CEREC SpeedFire - VITA SUPRINITY PC Crystallization;Glazing Process

65 71 165 D3639
44 D3639.201.01.02.02 10.2016
5Operation Sirona Dental Systems GmbH
5.4VITA SUPRINITY® PC crystallization/glazing process Operating Instructions CEREC SpeedFire
5.4
VITA SUPRINITY® PC crystallization/glazing
process
Fragment: CAUTION Furnace chamber size
Fragment: CAUTION Materials
For crystallization, combination firing (crystallization / glazing) and glaze
firing, only the supplied CEREC SpeedFire restoration holders "Glazing
support single unit" or "Glazing support multi unit".
1. To position/fix the restoration in place on the restoration holder, use
a small amount of CEREC SpeedPaste.
2. After this, place the restoration in the middle of the restoration holder
on the upper door insulation. Ensure that the holder or restoration do
not protrude out from the door insulation; otherwise, these may
collide with the furnace chamber.
The following programs are available:
● Crystallize
● Crystallize / glaze
●Glaze
Crystallize
The maximum number of three crowns must not be exceeded. The
maximum furnace chamber size must be observed. The glazing support
provided must be used for crystallization.
NOTICE
Maximum Observe restoration size
Observe the maximum Furnace chamber size when loading the furnace.
- Diameter: 38mm
- Height: 20 mm
The restoration (including with the Glazing Support Single/Multi Unit)
must not exceed this length (38mm) and height (20mm), otherwise the
chamber may be damaged.
NOTICE
Only use approved materials
Only load the furnace with approved materials, which must be assigned
uniquely to the heat treatment job in the furnace.
IMPORTANT
The less CEREC SpeedPaste used, the better.
However, to prevent direct contact of the restoration holder with the
restoration, a little CEREC SpeedPaste must be used to fix it in place.