Sirona CEREC SpeedFire - Intended Use

65 71 165 D3639
8 D3639.201.01.02.02 10.2016
1General data Sirona Dental Systems GmbH
1.7Intended use Operating Instructions CEREC SpeedFire
1.7
Intended use
The unit may only be used in conjunction with the Sirona CAD/CAM
system and is used for producing ceramic restorations.
The CEREC SpeedFire is suitable for sintering, painting and glazing ZrO
2
ceramics and for painting and glazing glass ceramics. Only heat
treatment processes sent as a job to the unit from the Sirona CAD/CAM
software may be performed. Heat treatments must be applied exclusively
to the restorations and materials assigned by the software.
The heat treatment is specified automatically by the CAD/CAM software
and is based on the material and dimensions of the restoration.
Follow the operating instructions
This unit must not be used for any other purpose. If the unit is used for
any purpose other than the one mentioned above, it may be damaged.
Intended use also includes compliance with these Operating Instructions
and the relevant maintenance instructions.
CAUTION
Follow the instructions
If the instructions for operating the unit described in this document are
not observed, the intended protection of the user may be impaired.
NOTICE
Use of acidic coloring liquids
Coloring liquids may contain acids which can escape during the
sintering process and damage the heating element.
➢ Recommendation: Only use Sirona water-based coloring liquids.