Sirona CEREC SpeedFire - Automatic Unit Search; Manual Unit Search

65 71 165 D3639
32 D3639.201.01.02.02 10.2016
4Transport and commissioning Sirona Dental Systems GmbH
4.6Commissioning Operating Instructions CEREC SpeedFire
4.6.4.2
Automatic unit search
✔ The unit must be switched on.
✔ The unit must be directly connected to the existing network with the
network cable.
1. Start the CEREC SW software.
2. Move the mouse cursor to the top of the window.
or
➢ Click the start window button.
 The system menu is displayed.
3. Click on the
"Configuration" button in the system menu.
4. Click on the
"Devices" button.
5. Click on the
"Scan for New Devices" button.
 All connected units are recognized.
6. Enter a name for the new unit.
4.6.4.3
Manual unit search
✔ The unit must be switched on.
✔ The unit must be directly connected to the existing network with the
network cable.
1. Start the CEREC SW software.
2. Move the mouse cursor to the top of the window.
or
➢ Click the start window button.
 The system menu is displayed.
3. Click on the
"Configuration" button in the system menu.
4. Click on the
"Devices" button.
5. Click on the
"Add Device (Manual)" button.
6. Select
"Network" .
7. Enter the network address.
8. Click on the
"Ok" button.
 The software attempts to contact the device.
9. Enter a name for the new unit.
If connection fails, check the network status.