Sirona CEREC SpeedFire - 7 Service Options; Temperature Test; Calibration

65 71 165 D3639
D3639.201.01.02.02 10.2016
51
Sirona Dental Systems GmbH 7Service options
Operating Instructions CEREC SpeedFire 7.1Temperature test
båÖäáëÜ
7
Service options
7.1
Temperature test
The temperature test is used to check the correct temperature for the
furnace and is initiated by Customer Service in exceptional cases. The
temperature test is only carried out on the instructions of the Customer
Service Center.
7.2
Calibration
Each unit leaves production with its own individual calibration that is
saved on the primary unit. Calibration is reserved for the service engineer
and is only carried out in rare cases, such as when replacing particular
spare parts.